By the way, what is an inductor? Just a piece of wire, right? Well, it's wrapped around a bit, but, how much does that really matter? None at all, as it happens. For equal capacitors C with ESR, choose C >= 1 / (2 pi Zo Fc), ESR = Zo (within say a factor of 2 or so), and L = (ESR)^2 / C. You can easily afford to just throw enough either side of an inductor to get a well damped network. They have appreciable ESR, and are cheap capacitance. For PS filters, the most common ingredients are electrolytic capacitors. Use a shunting R+C, or a series R||L, on one or both sides. If source and load are weird impedances (very high or low), then a damping network should be provided. You need to provide adequate termination, to get the expected frequency response. How near? And what is the impedance at and around Fc, is it exactly Zo, or something else? When properly terminated (source and load are resistors R = Zo), the resistance is, well, about that. So we really only have to worry about frequencies near Fc. At high frequencies, the output side capacitor has low impedance shunting the output. At low frequencies, the series inductor has low impedance, so if the source impedance is low, so is the output impedance. For this filter, the impedance peaks around Fc (the cutoff frequency - a special case of Fo), and drops either side. For example, the ratio of output voltage (supply ripple) to load current. So what is the impedance? Well, it's the ratio of voltage to current, at a given frequency. or does that have nothing to do with it? Thanks, BuzzĬlose! When working with LC networks, you'll find these pop up a lot: Fo = 1 / (2 pi sqrt(L C)) Zo = sqrt(L/C) In fact, this is all the calculator is really doing, starting from tabulated values that give the desired response (Butterworth, etc.) then scaling them proportionally for the desired cutoff and impedance. 5V/3A = 1.6 ohms? Microcontroller might consume 150ma and 5V. What kind of impedance would the output of the buck converter want to see? What kind of input impedance does the microcontroller module present to the converter? Is it as simple as. These filter calculators want to know the input and output impedance. I thought that instead of guessing values I'd actually use an online calculator to figure out the best components for a Pi filter at a given cutoff frequency. Through trial and error, I've found I can clean it up well will a simple LC filter between the output of the buck converter and the microcontroller. Ok, so when I am driving the motors I see PWM noise on the 5 volts coming from the buck converter module. (a) powering a few motors through PWM driven mosfets, and (b) into a buck converter module that outputs 5 volts for my microcontroller which is sending the pwm to a couple of BJTs which are in turn controlling the mosfets. I've got a project where I have a 12V power source.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |